Post Reply
If you were logged in you would gain 3 XP for posting a reply.
You are replying to:
Support Nibbits by linking to us:
Your
StarCraft 2 Resource
More from Nibbits: WarCraft 3 Maps | StarCraft Maps | StarCraft 2 Maps | Gamer Configs
Contact | Advertising | About | Pending Changes from Users | Become an Affiliate | Database Statistics | Terms of Use | Twitter | API Documentation
Spraying method has the advantage of the tooth surface constantly make fresh grease, can replace the old oil out, dust and abrasive mixture of material leaked on the tooth surface to avoid excessive impact occurs, the use of mechanical means active eruption refuel refueling difficult to overcome, reservoir cover uneven tooth surface defects. Is the most widely used method of a lubricant.
Coal pipe pumped in, to adjust its position higher than normal, a secondary air bigger than normal, more coal than normal, higher than normal firepower. When the exhaust opening try, the flame is still short, you should play slow cement kiln.coal pipe pumped in, where there is material thickness, shifting sand large, weight lifting is low, muddy kiln and other phenomena, are normal, indicating that the rotary kiln thick skin, lap after being burned, the effect is better, should continues to burn down.This approach is widely used in foreign countries,domestic large-scale equipment is also widely used.
Besides choosing the right way to spray suitable lubricants, need to determine the appropriate use of oil capacity, which should be based on equipment load, temperature, gear width, speed and gear tooth surface conditions and equipment operation are summarized considerations and adjustments, not blindly decreased fuel consumption, but also to follow a few guidelines frequent refueling; together spray system to always check the situation, such as pressure, oil pressure, spray pattern, oil drums, etc., to ensure the normal supply system; if spraying equipment attributed clothes equipment, but also selection of equipment suitable number of nozzles (each nozzle control 150mm wide tooth surface) and spray viewpoint, equipment spacing (20cm or so).
Pull out the cold pipe,appropriate lower primary,secondary air,reducing the amount of coal to keep the flame along and without rinse skin. When pull the coal tube,it is better to not pull out the whole,to prevent coal tube location falling back on the feed opening,wind coal mixed badly,pulverized coal combustion is not complete,and promote back ring growth.
Hongxing Machinery lays much emphasis on the machine quality and service for clients. We provides complete equipment for cement plant, rotary cement kiln with good quality, and we believe that quality is the best way to develop market. Thank you!
limestone rotary kiln: http://www.sinojawcrusher.com/companyproducts/Rotary-kiln.html